How to Connect Anz

How to Connect Anz

This manual applies to network configuration and pairing operations for Anz integrated devices and POS terminals.

Configure Anz

Connect Network to Anz Device

Power on the Anz device, tap MENU, enter the device password to enter the device management interfaceTap Settings on the device screen.

On the Settings page, tap Network Setup On the Network Setup screen, tap WLANOn the WLAN screen, tap Android Settings.

After entering Android Settings, tap Network & internetTurn on the Wi‑Fi switch Tap Wi‑Fi to enter the Wi‑Fi list screenSelect the target Wi‑Fi from the list.

Enter the Wi‑Fi password, then tap CONNECT to complete the Wi‑Fi connection. After successful connection, tap the connected Wi‑Fi to enter the Network details screenTap Advanced.

Record the IP address for later use in POS connection.

Posify Retail Pairing and Binding

Connect Network to POS Device

Go to the Wi-Fi settings interface of the device (operation paths for different devices: iPad: Settings - Wi-Fi, iMin/Sunmi: Settings - Network & internet - Internet). From the available network list, select the same Wi-Fi network as the Anz device.

Connect Anz

Open POS Tap the three‑line menu in the top‑left Tap Settings.

On the Settings page, tap Payment and locate the Anz configuration section. Enter the Anz device IP address Tap Connect.

After successful connection, the status changes to Connected.Once paired, you can use the Anz device to process payment transactions.