Zywell Zy608 LAN Connection

This document describes the connection and setup procedures for the Zywell Zy608 LAN printer.

Printer Self Test Page

Connect the printer to the computer using a USB cable as shown in the image.

Note: Keep the printer powered on.

Double‑click the driver file PrinterTest.exe to complete driver installation.

After driver installation, double‑click PrinterTest.exeSet the communication port to USBTap Advanced.

In Advanced settings, find and tap Set Net.

On the Net Setting page, enter SSID (Wi‑Fi name) and WIFI Key (Wi‑Fi password) under WIFI Setting Tap Set above contents.

The printer will automatically print a self‑test page. Record the IP Address shown on it.

Go to the device’s Wi‑Fi SettingsSelect the same Wi‑Fi network used by the Zywell Zy608 LAN printer.

Open POSTap the three‑line menu in the top‑leftTap Settings.

On the Settings page, tap PrintTap Add Printer in the top‑right corner.

From the printer model list, select ZyWell Zy608 LAN,tap Confirm.

In the configuration section, enter the IP Address printed on the self‑test page into the IP Address field.

In the Apply to section, enable the corresponding printer types, such as Receipt printer, Invoice printer, etc.

After setup, tap Print test page. When the pop‑up prompt “Find and connect devices on your local network” appears, tap Allow.

When the system shows Print test page success, this printer is connected, configuration is complete.